In just 10 easy steps we will explain how to change your FlagTrax flag or banner. This process takes an average time of 90 seconds.
Insert the FlagTrax Key into the keyhole in the Locking Cap at the bottom of the PushPull Rod to release it.
With the key inserted, pull the PushPull Rod a few inches out of the track. Remove the key and store in a safe place.
Pull the rest of the PushPull Rod out of the track. The best way is to coil the rod as you remove it. Do not coil less than 2’ or bend the PushPull Rod as this would damage it.
At the top of the PushPull Rod, pull out the top flag clip.
Remove the flag or banner by pulling the rest of the Sliders and bottom clip out of the PushPull Rod.
Attach the new FlagTrax flag or banner to the PushPull Rod by starting with the bottom clip, sewn to the tape at the bottom of the flag. The ‘wing’ on the side of the clip will be caught by the stainless steel Flag Tensioner positioned on the track. Ensure the ‘wing’ is on the correct side as the clip can be rotated if necessary. Some FlagTrax systems are assembled with two Flag Tensioners at different levels so different size of flags or banners can be used.Insert all remaining sliders into the PushPull Rod.The top flag clip must ‘click’ into place into the hole at the end of the rod.
Insert top flag clip and the PushPull Rod into the track, and push the flag or banner to the top of the track. The flag or banner will then tension correctly as the ‘wing’ on the bottom flag clip catches in the Flag Tensioner.
Ensure the PushPull Locking Cap locks into place at the base of the track.
Your flag or banner change is now complete!
For more information, please download our Installation Guide or check our video.
No comments:
Post a Comment